Common Air Conditioning Installation Mistakes
When an air conditioning system disappoints, the cause is often the design or installation rather than the equipment itself. A unit in the wrong place, the wrong size, or with a poorly planned drain can be noisy, inefficient, uncomfortable or prone to leaks for its whole life.
This guide explains the most common design and installation mistakes, why they matter, and how to spot them before work starts. It isn't about any particular installer. Most of these problems can be avoided with a proper survey and careful planning.
1. The wrong size of system
The mistake: choosing a unit by guesswork, by copying what a neighbour has, or by fitting the biggest model available "to be safe".
Why it matters: an undersized unit runs flat out and still can't keep the room comfortable on the hottest or coldest days. An oversized unit reaches the set temperature quickly, then cycles on and off. That wastes energy, removes less humidity, so the room can feel cool but clammy, and is often noisier.
How to avoid it: each room should be assessed individually, taking account of its size, orientation, glazing, insulation, use and any heat sources such as computers or kitchen appliances. Our guide to what size air conditioner you need explains the factors involved.
2. Poor indoor unit positioning
The mistake: putting the indoor unit wherever is easiest to reach from outside, rather than where it works best for the room.
Why it matters:
A unit blowing straight onto a bed, sofa or desk causes uncomfortable draughts.
A unit tucked into an alcove, behind a beam or above a tall wardrobe can't circulate air around the room properly.
A unit close to a heat source, such as above a radiator or near an oven, gets misleading temperature readings.
A unit fitted too close to the ceiling, or without the manufacturer's minimum clearances, can't draw in air properly and is harder to service.
In a room used mostly for heating, a unit high on the wall may need careful setting up, because warm air rises.
How to avoid it: agree the position with your installer while standing in the room, thinking about where you sit and sleep and how the air will flow. Where the best position means a longer pipe route, the extra work is usually worth it. Our guides to bedroom air conditioning and wall-mounted air conditioning have more on positioning.
3. Inadequate condensate drainage
The mistake: treating the drain as an afterthought.
Why it matters: when an air conditioner cools, it removes moisture from the air, and that water has to go somewhere. On a hot, humid day a single unit can produce a surprising amount. A drain without enough fall, with a dip that traps water, or with an outlet that becomes blocked will eventually overflow, and the first sign is often water dripping down the wall below the indoor unit. Water discharged onto a path or patio can also become slippery, and can freeze in winter.
How to avoid it: the drain should fall continuously from the indoor unit to a suitable discharge point. Where a gravity drain isn't possible, a condensate pump can be used, but it must be the right type, accessible and maintained. Our article on air conditioners leaking water explains what happens when drainage goes wrong.
4. Unsuitable outdoor unit positioning
The mistake: putting the outdoor unit in the most convenient spot rather than the right one.
Why it matters:
In a tight corner, a small enclosed yard or a light well, the unit keeps drawing in the hot or cold air it has just blown out. Efficiency falls and the unit may shut down on very hot days.
Close to a neighbour's bedroom window, it can cause noise complaints, and it may not meet the noise condition for permitted development.
High on a wall with no safe access, it is difficult and costly to service.
Directly on the ground in an exposed spot, it can be affected by snow, leaves and standing water.
In heating mode, the outdoor unit produces water when it defrosts. If that water has nowhere to go, it can freeze on paths.
How to avoid it: the outdoor unit needs free space around it as specified by the manufacturer, a solid wall bracket or base with anti-vibration mounts, a sensible drainage plan, and safe access for servicing. Our guide to air conditioning outdoor units covers this in detail.
5. Restricted airflow
The mistake: allowing the indoor or outdoor unit to be boxed in.
Why it matters: air conditioners work by moving air. A decorative cover over the outdoor unit, a fence built tight against it, shrubs that grow around it, or curtains and shelves around the indoor unit all restrict airflow. The system has to work harder, uses more electricity and may not reach the set temperature.
How to avoid it: follow the manufacturer's clearance requirements, think about what might be built or planted near the units in future, and only use covers or screens designed for that model.
6. Poorly considered pipework routes
The mistake: choosing the shortest or easiest pipe route without thinking about appearance, length or the manufacturer's limits.
Why it matters: every system has a maximum pipe length and a maximum height difference between the indoor and outdoor units. Long runs with many bends reduce efficiency and may need extra refrigerant. Pipework that isn't properly insulated can drip condensation or lose energy. A route across the front of a house, or trunking run carelessly across a wall, can spoil the appearance of a home for years.
How to avoid it: discuss the route before installation. Ask where the pipes will go inside and outside, how long the run will be, and whether it will be run in trunking. Our guide to air conditioning trunking and pipework shows the options.
7. No thought for maintenance access
The mistake: fitting units where they can't easily be reached once the job is finished.
Why it matters: filters need cleaning regularly, and the system needs servicing at least once a year. An indoor unit over a staircase, or an outdoor unit two storeys up with no safe access, makes every visit harder and more expensive, and makes it more likely that maintenance will be skipped.
How to avoid it: check that you can reach the indoor unit's filters safely, and that an engineer can reach the outdoor unit without special access equipment, unless that has been agreed and costed.
8. Cutting corners on electrical work
The mistake: connecting the system without the right electrical supply or certification.
Why it matters: most systems need a dedicated circuit from your consumer unit, with the correct protection and an isolator near the outdoor unit. In England, installing a new circuit in a home is notifiable work under Part P of the Building Regulations. It must be done by an electrician registered with a competent person scheme, or approved through your local building control.
How to avoid it: check that the quote includes the electrical work, and ask for the electrical installation certificate when the job is finished.
9. Skipping proper commissioning and handover
The mistake: finishing the job without testing the system properly or showing you how to use it.
Why it matters: before a system is filled with refrigerant, its pipework should be pressure tested for leaks and evacuated with a vacuum pump to remove air and moisture, following the manufacturer's instructions. Skipping these steps can lead to leaks, poor performance and early failure. Without a proper handover, many people never learn how to use the modes, timers and settings that make the system comfortable and economical.
How to avoid it: ask how the system will be tested and commissioned, and expect to be shown how to use the controls and clean the filters. Our guide to air conditioning remote symbols is a useful reference afterwards.
10. Work by people without the right certification
Installing a split air conditioning system means handling refrigerant, which is a fluorinated greenhouse gas (F-gas). In the UK, engineers who handle refrigerant must hold the appropriate F-gas qualification, and companies that install, maintain or service this equipment must hold an F-gas company certificate. Fitting a system yourself and paying someone to "just connect it", or buying a DIY pre-charged kit, carries real risks. Our article on the dangers of DIY installed air conditioning explains why.
A checklist before installation day
Sizing. What a good answer looks like: Each room assessed, with the capacity of each unit explained.
Indoor unit position. What a good answer looks like: Agreed with you in the room, clear of beds, desks and obstructions.
Outdoor unit position. What a good answer looks like: Free airflow, away from neighbours' windows, safe to service.
Drainage. What a good answer looks like: A clear route with continuous fall, or a suitable pump.
Pipe route. What a good answer looks like: Length and route explained, trunking colour and position agreed.
Electrical work. What a good answer looks like: Dedicated circuit included, with certification.
Commissioning. What a good answer looks like: Pressure test, vacuum and full handover.
Certification. What a good answer looks like: F-gas certified engineers and company certificate.
Our guide on how to compare air conditioning quotes explains what else to check before you choose an installer.
All of our installations are carried out by our own engineers, never subcontractors. If you'd like us to survey your home, call 01772 288651 or use the quote form at the bottom of this page.
Frequently asked questions
What is the most common air conditioning installation mistake?
Poor sizing and poor positioning are among the most common, because they are easy to get wrong without a proper survey and they affect comfort and running costs for the life of the system.
Can a badly installed air conditioner be fixed?
Often, yes. Indoor and outdoor units can usually be repositioned, drains rerouted and controls set up properly. A system that is badly oversized or undersized for the room is harder to put right without replacing equipment.
Why is my air conditioner dripping water indoors?
The most common cause is a blocked or poorly sloped condensate drain. See our guide to air conditioners leaking water.
Last updated: November 2026.
Sources
Request a Free Quote
Leave your details and our team will be in touch.

